As car manufacturers pushing up the power of the road going cars continuously in the recent years, the tuning market was quick to follow so aquamist is now offering a twin FAV bundle to facilitate the demand for more water/methanol flow. It is recommend to use this bundle with the 3000cc pump option.      

Direct fuel injected engine are now accounted for 90% new cars. It is a welcoming trend for the performance cars, more power is achieved with good fuel economy. For those who wish to push the power barrier further, squeezing more fuel out of these direct injection engine is a real problem. A secondary set of fuel injector for each port is one solution, but requires running two fuel lines to the engine bay and a second fuel pump. An third party programmable fuel controller is also required to drive them.

Aquamist direct-port Methanol injection system is another solution to provide the additional fuel for these engines. It comes in one neat package costing a fraction of the other alternative. Note the Aquamist is the only system has ability to decode those complex Direct-injection signals. By tracking the fuel flow in real time, it delivers the additional fueling seamlessly and reliably without any mapping. 

Compared to gasoline, methanol has an higher octane value of 108+ and three times the latent heat by evaporation. It is exceptionally effective when a jet is placed at the exit of an intercooler in addition to the port jets. These in no reason why we can't classify this setup as M10, M50 .... M85. Indy engines used to run 100% methanol. All aquamist components are also ethanol compatible. No reason why a blend of Methanol and ethanol are mixed to create a E30/M70 blend to increase the internal energy of methanol.      

Crack pressure: 1bar.  

We are offering a bundled Twin-FAV direct port upgrade for 4, 5, 6, 8 and 10 cylinder engines.

Package contains:
1. Multi-port hex manifold option (4,5,6,8,10)
2. Checkvalve jets (one per cylinder) 
3. M8-1/8 NPT jet adaptor with blanking plug (one per cylinder)
4. One checkvalve for post IC jet 
5. One 4mm to 1/8 BSP compression fitting for post IC jet (hex port)  
6. 4mm high temperature PTFE hose
7. Twin "hi-flow" FAV + "hi-flow" flow sensor tube.
8. IP65 red harness and flow sensor cable. 
9. Base plate with acetal end caps for FAVs and hex manifold
10. High flow flow sensor cable